compact size: 135mm x 75mm
fully integrated all in one solution:
Arduino 2560-R3 compatible (works with Sprinter, Repetier-Firmware, Marlin out of the box)
ATmega16U2 (with enhanced firmware) for high speed USB serial connection (up to 2MBit)
Makeboard Pro is specially designed by Micromake Technical Team to solve the problem which usually occurs on the open source control board of Ramps 1.4 3d printers.
We had fully consider about the mistakes that customers usually make in the beginning, so we use different color to dist..
Ultra Stable Board Control Board MKS-BASE V1.6
It gather all function on one board, which solved the Ramps1.4 combination interface problem, which easily out of order
Using A4982 as a motor drive, the SOP package, the effect of heat dispelling is better
Circuit board uses the high qua..
3D printer Smoothieware controller board MKS SBASE V1.2 opensource 32bit Smoothieboard Arm support Ethernet preinstalled heatsinks
MKS SBASE is a latest motherboard for 3D Printer ,designed by Makserbase (MKS).
It is based on ARM platform and uses 3..
Save More than 200LE !
This is the DIY kit for assembling your own 3D printer fast and easy starting ,This 3D printer electronic kit is the brain of choice for most 3D printer. We offer an affordable and universal solution to start building your 3D printer. The components included in this kit ..
1. PCB Heatbed MK2B
Relative latest version Mk2a, a major upgrade to the 12V 24V dual power.
12V connection: a cable connected 1, 2 and 3 in addition a line connected simultaneously
24V Connection: a line then 2, then 3 in addition a line (not connected 1 vacant)
This is for one power module for controlling 3D printer heated bed, it is also can be used to drive other non-inductive loads. If you plan to use silicone heater of large area heated bed, you most likely will overcome limitations for the current, that can handle your current 3d printer&nbs..
English Version TFT touch screen
This is the first 3D printer motherboard developed by CBD-Tech which has been in the Chinese market for six months with more than a thousand units sold so far.
The board is equipped with a 32-bit high-speed ARM chipset (STM32F103ZET6) which results in ..
It using 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage. An insulating layer over a wide range of temperatures, up to 80 degrees. Is the common connection of thin copper wire can not match. Not easy to pull off, plug it convenient, for ease of u..
Using STM32F407 high-speed ARM, independent research and development, full-size color touch screen, support a variety of chip software, a variety of models, support dual Z, double Y, double E, a total of 7 motor, support U disk, network port, 14 languages , The new design interface, ..
MKS Robin is created by MAKER BASE(MKS),which assemble with 2.8/3.2inch TFT touch screen already . Also, it’s easy for users to configure the firmware and update via SD . This controller is good for 3D printer manufactories.
1.Use 32bit 32-bit high-speed ARM chi..