3D Printer Egypt Control Board MKS-BASE V1.6 Ultra Stable Board

3D Printer Egypt Control Board MKS-BASE V1.5

Ultra Stable Board Control Board MKS-BASE V1.6

Feature:
It gather all function on one board, which solved the Ramps1.4 combination interface problem, which easily out of order
Using A4982 as a motor drive, the SOP package, the effect of heat dispelling is better
Circuit board uses the high quality of 4 layer board,optimize heat dissipation;Ramp Is 2 layer board
Using special power supply chip, support the 12v-24v power input, solve the problem of Ramps voltage conversion of chip fever
Can accept 24 v input, under the same system power can reduce the current hot bed to 1/4, effectively solve the problem of hot bed MOS tube heating
The firmware can use open source firmware Marlin, configuration are exactly the same with ramps1.4 , can be directly replace ramps1.4 also
Can be connected directly to Ramps1.4, 2004 LCD control board and the LCD board (12864)

Descriptions:

- This is the combination of MEGA2560 + RAMPS1.4 + 5 x A4982 drivers (remix board)
- Firmware can use the same configuration as RAMPS1.4
- It is suitable for dual-Extrude printer
- Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on  board
- 3x temperature ADC connectors for thermistors
- Up to 5 motor drivers with A4982
- 4x PWM capable power mosfet outputs  with voltage selector for MainPower.(Bed, Extruder0Extruder1, Fans)
- 4 layers PCB, optimize heat dissipation.
- 6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
- Recoverable fuse for short-circuit protection.
- USB Driver Chip FT232RL, you can get files from ftdichip to setup driver: Ftdi-x86.zip


Package included:

1 x Control Board MKS-BASE V1.6
1 x USB cable

Write a review

Note: HTML is not translated!
    Bad           Good

  • Views: 6233
  • Product Code: MKS-BASE V1.6
  • SKU Code: A2-1
  • Availability: 4
31 Product(s) Sold
  • 1,175.00LE

Tags: 3D, Printer, Egypt, Control, Board, MKS-BASE, V1.5, MKS-BASE, V1.2, 3D-Printer, Accessories, ramps, ramps1.4

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.
Name
Email
Phone
Comments