3D Printer MK8 Remote Extruder Aluminum Frame clamp Block DIY Kit

SOLD OUT 3D Printer MK8 Remote Extruder Aluminum Frame clamp Block DIY Kit

3D Printer MK8 Remote Extruder Aluminum Frame Block DIY Kit Makerbot Dedicated Single Nozzle Head

 

3D printer accessories, 
MK8 Remote extruder aluminum block DIY kit, 
Makerbot dedicated single nozzle, 
 
 
Package:
Aluminum block built into frame
Aluminum lever/fulcrum
Idler wheel for 1.75mm filament
Extruder drive gear 
High tension spring 
Assembly screws 

MK8 remote extruder step

1, the first bracket on the motor, note the direction Oh Meme da, and then on top of the motor shaft with a wrench black top wire in the motor shaft gear above 40

2, the black square aluminum block on top

3, the black screws on the motor, brackets, and square aluminum block

4, and then as long as the parts of the two screws SHCS

5, Shang Hao screws, and then set a small aluminum block section, the bearing shown in Figure put away, that fixed short flat head screws

6. After fixing, on a large aluminum block above the flat head screw fitting longish fixed wear pads

7. After fixing, then showing the operation

8, finally connect fittings on ok

Write a review

Note: HTML is not translated!
    Bad           Good

  • Views: 3138
  • Product Code: 3D EXT FRM REM KIT
  • SKU Code: A3-3
  • Availability: SOLD OUT
51 Product(s) Sold
  • 175.00LE

Tags: 3D Printer MK8 Remote Extruder Aluminum Frame clamp Block DIY Kit, 3D EXT FRM REM KIT, 3D Printer Accessories