3D Printer Mechanical Endstop Switch Module for 3d Printer

Description

Features:
This 3d Printer Mechanical Endstop Switch Module It using 22AWG wire, copper wire inside is very thick, and Endstop Switch  can be handel to current 2A, 300V voltage. An insulating layer over a wide range of temperatures, up to 80 degrees. Is the common connection of thin copper wire can not match. Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one, you can use the direct plug

Mechanical Endstop Board Size: Approx. 39 x 16 x 7mm / 1.54 x 0.63 x 0.28 inch
Endstop Cable Length: Approx. 70 cm / 27.56 inch

Connection Description for the Mechanical Endstop Switch Module   :

Red line connecting VCC (ramps of +)
Connect the black wire GND (ramps of -)
Green Line connection SIGNAL (ramps in s)