AVR USB JTAG ICE Programmer, Emulator and Debugger
Small Elegent AVR JTAG ICE emulator (metal case / overcurrent protection / wide voltage / buffer chip / cable)
Product Information Product information
Our products only DESCRIPTION or electronic documentation, no technical advisory support, please carefully shot beginners, Thank you for understanding.
Ultra-stable AVR-USB emulator features:
1. The new design, plus a buffer chip (red firmware to prevent improper operation);
2. added 0.5A recoverable fuse (to prevent short circuit burned out the computer motherboard);
3. The wide operating voltage, support 3.3V;
4. This emulator firmware unlimited upgrades, both upward and downward compatible and support the latest AVR STUDIO software 4.12 / 4.14 / 4.16 / 4.17 / 4.18 !!!!
AVR JTAG with Atmel's AVR Studio + iccavr or WINAVR cooperating complete set of on-chip JTAG-based debugging tool interface, supports all AVR 8-bit RISC instruction with a JTAG port of the microprocessor. JTAG interface is a 4-wire IEEE 1149.1 compliant test access port (TAP) controller. The IEEE standard provides an effective board connectivity testing standard methods (boundary-scan). Atmel's AVR devices has been extended to support full programming and on-chip debug function.
AVR JTAG emulator chip used for hardware emulation, such as single-step program execution, set breakpoints, you can learn more by hardware emulation operation of the chip inside the program. AVR JTAG emulator chip is mainly used to simulate the operation, but also can be programmed through the JTAG interface chip (the program into the chip).
ATmega128, ATmega128L, ATmega16, ATmega162, ATmega162V, ATmega165, ATmega165V, ATmega169, ATmega169V, ATmega16L, ATmega32, ATmega323, ATmega323L, ATmega32L, ATmega64, ATmega64L (support all AVR microcontrollers with JTAG port).
The emulator connected to one end of the USB port, the other end connected to a standard ten-pin JTAG interface, compatibility is superior than the average performance of similar products, PC software AVRstudio, compatible with 4.12 / 4.13 / 4.17 / 4.18 and later, the firmware can be upgraded;
A 1.AVR-USB emulator, with aluminum housing;
2.50cm 10PIN standard JTAG download cable one;
3. anti-static bag packaging