All part are injection molded using a new high-strength ABS plastic material. Long injection time so that each one corner piece are exceptionally full, thereby safeguarding the accuracy and strength of the product.
The piece opened oblique angle mounting groove, with two corner pieces to ..
The Kossel is a parametric Delta robot, built in 2012 by Johann Rocholl. The model is named after German biochemist Albrecht Kossel, who was a pioneer in the study of genetics.
The kit includes plastic printed parts only; always printed from the latest Git Source.
Battery Tybe AA, AAA and 9 Volt (6 F22) Ni-MH/Ni-CD Rechargeable Battery.
Never use it under high temperature (OutDoor).
It should only be used in door.
Input Power : 110 V / 220 V AC, 50/60Hz, 50 mA
Output Power : 2.4 VDC * 2 150 mA,
Gaussmeter Tesla meter WT10A WT-10A the fluxmeter surface magnetic field tester with Ns function With Metal probe
Handheld digital WT10A gauss meter used to measure the magnetic field of the permanent magnet material surface, DC motors, speakers, magnetic separator,&..
JK-DMS-HP digital Magnetic Stirrer heating plate Laboratory Mixer
Power [W] 500;
Motor type brushless DC motor;
Motor rating input [W] 3;
Motor output power [W] 4;
Nano-ceramic material discs work surface / stainless steel;
Working plate dimensions [mm] ..
2 in 1 function Voltmeter Ammeter, Easy installed.
Measurement accuracy: ±0.1%
Refresh rate: about 300mS / time
Display: Dual four 0.28 "digital tube（blue and red）
Measuring range: DC 0A-10A.
Measuring range: DC 0V-100V.
Input range: DC4V-30V
Display Color: Blue(Amme..
Can withstand high current overload, the maximum current up to 10A, driving 200w motor.
This drive also has a brake function can be quickly.
The drive uses the full two half-bridge driver IC +low resistance N-channel MOSFET components.
Complete two half-bridge driver IC relia..
These 6mm eccentric spacers are used with V wheels and Open Builds V-Slot (TM) aluminum extrusions to create simple, affordable linear motion systems. The spacer has an off-center 5mm bore, which allows you to tighten the wheel against the extrusion. The spacer sits in a 7.12mm hol..