24-Channel Servo ControllerThis is a 24-channel servo controller designed by ToRobotFeatured with a 32-Bit CPU, it provides better speed, accuracy and stability.The servo controller can be easily controlled by either a easy-to-use software or UART (TTL).Features:• 32-bit CPU• Operating Voltage: refe..
DC motor driver 45V 46A H bridge can be full PWM positive and negative magnetic coupling isolation smart carSpecsAplicable voltage rang : DC 5.9v-45vMax Continous Currnet: 46APeak current : 138AMax Continous Power : 2000wPWM Duty cycle : 0-100%PWM freq. Affair : 0-100KhzInput Signal Level : TTL (3.3..
Module parameters:Function: It can control the positive and negative rotation
of 2 motors (such as balancing the car, only one module is needed)Voltage: 7.6~40VCurrent: Module with current limit protection, 2A
(overcurrent will not be powered off, only limit the maximum output current)Control: 4 P..
Adjustable AC to DC Power Adapter 3-12V 2A Motor Voltage Speed Controller with US PlugFeatures
●Adjustable voltage from low to high to meet your different needs
●Energy efficient and stable AC / DC power supply to protect your
●100cm + 100cm long cable for convenient use
B T S 7 9 6 0 Bis
a fully integrated high current half bridge for motor drive applications. It is
part of the NovalithICTM family containing one p-channel high side MOSFET and
one n-channel low side MOSFET with an integrated driver IC in one package. The
power switches utilize vertical MOS t..
DESCRIPTIONThe CA3086 consists of five general-purpose silicon NPN transistors on a common monolithic substrate. Two of the transistors are internally connected to form a differentially connected pair.The transistors of the CA3086 are well suited to a wide variety of applications in low-powe..
This motor driver board, originally designed by Dagu for their Rover 5 platform, is ideal for any small 4-wheel drive robotic vehicle. With four motor outputs, four encoder inputs and current sensing for each motor, it's a must-have when implementing omni or mechanum wheels.Features4 x Low Resistanc..
The Descriptionaverage current control, two-phase sinusoidal current drive output- DC 9 ~ 42V power supply- optically isolated signal input / output- overvoltage, undervoltage, overcurrent, and white short-circuit protection- Input voltage DC 12 ~ 48V input- The input current of 1 to 5 amps, select ..
L293D This is a very useful chip. It can actually control two motors independently. We are just using half the chip in this lesson, most of the pins on the right hand side of the chip are for controlling a second motor, but with the Raspberry Pi, we only have one PWM output...
L297Stepper Motor ControllerThe L297 Stepper Motor Controller IC generates four phase drive signals for two phase bipolar and four phase unipolar step motors in microcomputer-controlled applications. The motor can be driven in half step, normal and wawe drive ..
Description: The L298N is a high voltage, high current, dual full-bridge motor driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motors.Comes in a staggered, 15-lead Multiwatt package. Check below for a bre..
Low quiescent currentWide supply voltage range: 2.5V-12V800mA continuous current output capability per
channelLower saturation voltageTTL / CMOS output level compatible, and can be
directly connected to the CPUOutput built-in clamp diodes for inductive loadIntegrated control and drive i..