RXC6 RF receiver 433 MHZ - 4 Channel

RXC6 wireless module, is a high sensitivity 433Mhz receiver module. Integrated 4 bit decoding and very good signal to noise ratio offered by the Superheterodyne Receiver

Quick Specs

Frequency: 433.92Mhz
Operating voltage: 3 to 5.5V DC
Quiescent Current: 4mA
Receiver sensitivity:-105DB
Size: 30 * 14 * 7mm
External antenna: 32CM single core wire, wound into a spiral

RXC6 Board Layout

Pin Functions

1 ANT - External Antenna - Spiral 32cm
2 GND - Ground
3 External LED
4 External Switch for programming mode
5 VT: Will flash when signal receive
6 Data D0
7 Data D1
8 Data D2
9 Data D3

Jumper Settings - Directly Translated from Chinese

T2 & T1 Open - Momentary Default
T2 Closed, T1 Open - Latching Mode
T2 Open, T1 Closed - Toggle Mode

Learn button

Press and hold the key for 2 seconds , learn indicator light at this time that has entered the state of learning; learning key release, press any remote control - a key indicator flashes four times indicates success in learning, and exit learning mode.

To Reset, Press and hold learning key indicator lit, hold about 8 seconds after the light is off, all the code has been successfully cleared.