SN65HVD230 can be used in high interference environment. The device has the ability to send and receive good in different rates
Fully compliant with ISO11898 standards;
High input impedance, allowing for 120 nodes;
Low current standby mode, the typical current is 370μA;
Signal transfer rate up to 1 Mb / s;
Thermal protection, open fail-safe function;
With anti momentary interference protection function bus;
Slope control, reduce radio frequency interference (RFI);
Differential receiver with a wide range of anti-common mode interference, electromagnetic interference (EMI) capabilities.
Mode and control logic
SN65HVD230 high speed, ramp and three different wait modes. The mode of control can be achieved by controlling pin Rs. Figure 2 is a SN65HVD230 CAN bus system in a typical application diagram. Can be seen from the figure, CAN controller is connected to the output pin Tx SN65HVD230 data input terminal D, this CAN node can send data transferred to the CAN network; CAN controller and receive pins of Rx and SN65HVD230 R data output coupled for receiving data.