TLE6209R D-Mos Motor control driver H bridge SPI controlled IC SMD
Description
Description
The TLE 6209 R is an integrated power H-Bridge with D-MOS output stages for driving bidirectional loads such as DC-Motors. The design is based on Infineons Smart Power Technology SPT which allows bipolar, CMOS and power D-MOS devices on the same monolithic circuit. Operation modes forward (cw), reverse (ccw) and brake are invoked by two control pins PWM and DIR. Protection and a reliable diagnosis of overcurrent, openload, short-circuit to ground, to the supply voltage or across the load are integrated. Detailed diagnostic information is given via the 8 bit SPI status word. An integrated chopper current limitation limits the current e.g. to reduce power dissipation during mechanical block of a DC motor. Several device parameters can be set by the SPI control word. A three-level temperature monitoring with prewarning, warning and shutdown is included for controlled operation under critical power loss conditions. The full protection and diagnosis capability make the device suitable especially for safety relevant applications, e.g. in automotive ECUs.
Features:
• Delivers up to 6 A continuous and 7 A peak current
• Optimized for DC motor management applications
• Very low RDS ON of typ. 150 mΩ @ 25 °C per switch
• Operates at supply voltages of up to 40V
• Overvoltage Protection against transients up to 45 V
• Outputs fully short circuit protected
• Standard SPI-Interface, daisy chain capability
• Adjustable chopper current regulation of up to 7 A
• Temperature monitor with prewarning, warning and shutdown
• Over- and Undervoltage-Lockout
• Open load detection
• Detailed load failure diagnosis by SPI
• Minimized power dissipation due to active free-wheeling
• Low EMI due to voltage slope regulation
• Very low current consumption (typ. 20 μA @ 25 °C) in stand-by (Inhibit) mode
• Enhanced power PG-DSO-Package
• Green Product (RoHS compliant)
• AEC Qualified
Additional information
Weight | 0.005 kg |
---|
You must be logged in to post a review.
Pin Header Female 1×15 Straight Connector 2.54mm pitch
2N2222A Plastic
PHOTO DIODE BP333 infrared IR LED
LED Capacitive Touch Dimmer PWM Control Board
Refund Policy for UGE Electronics “Https://uge-one.com “
1. Returns and Refunds
Thank you for shopping at UGE Electronics “Https://uge-one.com “. If you are not entirely satisfied with your purchase, we’re here to help.
2. Eligibility for Refund
To be eligible for a refund, please make sure that:
– The item was purchased in the last 14 days.
– The item is in the original packaging.
– The item isn’t used or damaged.
3. How to Initiate a Refund
To initiate a refund, please contact our customer support at [[email protected]] or [01066552125]. Provide your order number and details about the product you would like to return.
4. Refund Processing Time
Once we receive your item, we will inspect it and notify you that we have received your returned item. We will immediately notify you on the status of your refund after inspecting the item.
If your return is approved, we will initiate a refund to your credit card (or original method of payment). You will receive the credit within a certain amount of days, depending on your card issuer’s policies.
5. Shipping Costs
Shipping costs are non-refundable. If you receive a refund, the cost of return shipping will be deducted from your refund.
6. Exchanges
If you wish to exchange an item, please contact our customer support. You will be responsible for the return shipping costs, and we will cover the shipping costs of the replacement item.
7. Damaged or Defective Items
If you received a damaged or defective product, please contact us immediately for assistance. We will work with you to resolve the issue promptly.
8. Contact Information
If you have any questions about our Refund Policy, please contact us at [[email protected]].
Important Note: This Return & Refund Policy is applied only for Orders invoiced VIA UGE Electronics, and regarding any Orders has been invoiced VIA any Other Vendor you can check the Return & Refund Policy of this Vendor VIA the Vendor Stroe Page, and it’s not our responsibility for any issue between you and the Vendor.
Reviews
There are no reviews yet.