Arduino Uno DIY

Description

Description: This kit contains everything you need to build your very own Uno-compatible development board! Simply follow the Assembly Guide and after some basic soldering, you’ll have made a fully-functional Arduino-compatible development board .

After the board is assembled, it can be powered by an USB to UART module or a regulated 6-15VDC power supply connected to either the DC Barrel jack or the new JST footprint.

Note: You will need either an FTDI Basic or any compatble USB to UART module to load code using the Arduino IDE. Buy from Here

Kit Includes:

• 1 x Arduino-Compatible PTH Kit PCB
• 1 x MCP1700 3.3V Voltage Regulator
• 1 x 5mm Green LED
• 1 x 5mm Red LED
• 2 x 330Ohm Resistor
• 2 x 10kOhm Resistor
• 1 x 16MHz Crystal
• 2 x 22pF Ceramic Capacitors
• 5 x 0.1uF Ceramic Capacitors
• 2 x 10uF Electrolytic Capacitors
• 1 x LM7805 5V Regulator
• 1 x Diode 1N4001
• 1 x Resettable Fuse PTC
• 1 x 28-Pin DIP Socket (To seat your ATMega)
• 1 x Push Button Reset Switch
• 2 x 6-Pin Female Headers
• 2 x 8-Pin Female Headers
• 1 x 6-Pin Right Angle Header (To connect your FTDI Basic)
• 1 x 0.1uF Capacitor
• 1 x DC Barrel Jack

Documents:

• Schematic
• Eagle Files
• Assembly Guide